Origami polar bear step by step. Detailed instructions with photos. Work of medium difficulty.
Materials:
- A square piece of paper, one side of which is white and the other is brown;
- Brown felt-tip pen (paper or plastic eyes).
In this work, the sides of the paper square are 15 cm. Due to the fact that the paper is brown on one side, you can immediately highlight the color of the nose. But, in principle, you can fold the bear out of completely white paper, and then sketch the nose with a brown felt-tip pen.
Origami Polar Bear from Paper in Stages
Prepare paper.
Fold it into a triangle.
Then fold again from right to left into an even smaller triangle.
Thanks to these actions, we will make cross folds.
Bend the top corner down, width — 7 mm.
Fold down again in the same area.
Fold back the sides. Here we form the nose of the bear.
Flip over to the other side.
Guided by the lines in the photo, bend both sides to the middle. Right.
Left.
Lower the top corner down to a crease in the center.
Now straighten all the bent sides.
Bring the bottom corner up to the first fold.
Bring back the sides, that is, bend towards the center.
Further, the photo shows the lines, following the example of which it is necessary to bend both sides of this model to the center. Right.
Left.
These are the future paws of the origami animal, but at this stage they are too wide, so they should be slightly narrowed. Again, pay attention to the photo, which shows the lines along which you need to bend the sides back.
But in this form, the bear will be thin, so we will make sure that the torso is visible along the edges of the paws. To do this, bend back the paws bent in the previous step, first making a small crease. On right.
Left.
Lower the bear’s head down.
Fold back the corners of the head.
Flip over to the other side. And fold the corners back, making small folds. On right.
Left. This way we get ears.
Flip over to the other side.
Draw or glue the eyes, bend up the paws. Origami polar bear made of paper is ready.
By slightly bending the back, the bear can be placed in a vertical position.
Even more ideas in the selection — origami animals.
Related Post:
